CheckPoint 156-215 Free Dowload, The Most Effective CheckPoint 156-215 Study Guide Are The Best Materials

Welcome to download the newest Pass4itsure ns0-155 Practice Test dumps: http://www.pass4itsure.com/ns0-155.html
Amazing,100% candidates have pass the CheckPoint 156-215 exam by practising the preparation material of Flydumps,beacuse the brain dumps are the latest and cover every aspect of CheckPoint 156-215 eaxm.Download the dumps for an undeniable success in CheckPoint 156-215 exams.

QUESTION 126
Which rule is responsible for the installation failure?
“Pass Any Exam. Any Time.” – www.actualtests.com 49 Checkpoint 156-215-71: Practice Exam

A. Rule 4
B. Rule 3
C. Rule 5
D. Rule 6

Correct Answer: A QUESTION 127
If you experience unwanted traffic from a specific IP address, how can you stop it most quickly? ActualTests.com
A. Check anti-spoofing settings
B. Configure a rule to block the address
C. Create a SAM rule
D. Activate an IPS protection

Correct Answer: C QUESTION 128
You are evaluating the configuration of a mesh VPN Community used to create a site-to-site VPN. This graphic displays the VPN properties in this mesh Community
“Pass Any Exam. Any Time.” – www.actualtests.com 50 Checkpoint 156-215-71: Practice Exam

Which of the following would be a valid conclusion?
A. The VPN Community will perform IKE Phase 1 key-exchange encryption using the longest key Security Gateway R71 supports.
B. Changing the setting Perform IPsec data encryption with from AES-128 to 3DES will increase the encryption overhead.
C. Changing the setting Perform key exchange encryption with 3DES to DES will enhance the VPN Community’s security, and reduce encryption overhead.
D. Change the data-integrity settings for this VPN CommunitybecauseMD5 is incompatible with AES.

Correct Answer: A
QUESTION 129
You just installed a new Web server in the DMZ that must be reachable from the Internet You create a manual Static NAT rule as follows:
“Pass Any Exam. Any Time.” – www.actualtests.com 51 Checkpoint 156-215-71: Practice Exam

“web_publicIP” is the node Object that represents the public IP address of the new Web server. “web_privateIP” is the node object that represents the new Web site’s private P address You enable all settings from Global Properties > NAT.
When you try to browse the Web server from the Internet, you see the error ‘page cannot be displayed” Which of the following is NOT a possible reason?
A. There is no route defined on the Security Gateway for the public IP address to the private IP address of the Web server.
B. There is no Security Policy defined that allows HTTP traffic to the protected Web server.
C. There is an ARP entry on the Gateway but the settings Merge Manual proxy ARP and Automatic ARP configuration are enabled in Global Properties. The Security Gateway ignores manual ARP entries.
D. There is no ARP table entry for the public IP address of the protected Web server

Correct Answer: A QUESTION 130
Which of the following SSL Network Extender server-side prerequisites is NOT correct?
A. The Gateway must be configured to work with Visitor Mode.
B. There are distinctly separate access rules required for SecureClient users vs. SSL Network Extender users.
C. To use Integrity Clientless Security (ICS), you must install the IC3 server or configuration tool.
D. The specific Security Gateway must be configured as a member of the Remote Access Community

Correct Answer: B QUESTION 131
You need to determine if your company’s Web servers are accessed an excessive number of times from the same host. How would you configure this in the IPS tab?
A. Successive multiple connections
B. Successive alerts
C. Successive DoS attacks
D. HTTP protocol inspection

Correct Answer: A QUESTION 132
What does it indicate when a Check Point product name includes the word “SMART”?
A. Stateful Management of all Routed Traffic.
B. This Check Point product is a GUI Client.
C. Security Management Architecture.
D. The Check Point product includes Artificial Intelligence.

Correct Answer: C QUESTION 133
How many times is the firewall kernel invoked for a packet to be passed through a VPN connection?
A. Three times
B. Twice
C. Once
D. None The IPSO kernel handles it Correct Answer: C
QUESTION 134
When attempting to connect with SecureClient Mobile the following error message is received. The certificate provided is invalid. Please provide the username and password.
What is the probable cause of the error?
A. The certificate provided is invalid.
B. The user’s credentials are invalid.
C. The user attempting to connect is not configured to have an office mode IP address so the connection failed.
D. There is no connection to the server, and the client disconnected.

Correct Answer: A
QUESTION 135
The fw stat -l command includes all of the following except:
A. The number of packets that have been inspected
B. The date and time of the policy that is installed.
C. The number of times the policy has been installed ActualTests.com
D. The number of packets that have been dropped

Correct Answer: A
QUESTION 136
Although SIC was already established and running, Joe reset SIC between the Security Management Server and a remote Gateway. He set a new activation key on the Gateway’s side with the cpconfig command and put in the same activation key in the Gateway’s object on the Security Management Server Unfortunately SIC cannot be established. What is a possible reason for the problem?
“Pass Any Exam. Any Time.” – www.actualtests.com 54 Checkpoint 156-215-71: Practice Exam
A. The installed policy blocks the communication.
B. Joe forgot to reboot the Gateway.
C. Joe forgot to exit from cpconfig.
D. The old Gateway object should have been deleted and recreated.

Correct Answer: C
QUESTION 137
The TotallyCoolSecurity Company has a large security staff. Bob configured a new IPS Chicago_Profile for fw-chicago using Detect mode. After reviewing logs, Matt noticed that fw- chicago is not detecting any of the IPS protections that Bob had previously setup. Analyze the output below and determine how can correct the problem.

A. Matt should re-create the Chicago_Profile and select Activate protections manually Instead of ActualTests.com per the IPS Policy
B. Matt should activate the Chicago_Profile as it is currently not activated
C. Matt should assign the fw-chicago Security Gateway to the Chicago_Profile
D. Matt should change the Chicago_Profile to use Protect mode because Detect mode will not work.

Correct Answer: C
QUESTION 138
Which statement below describes the most correct strategy for implementing a Rule Base?
“Pass Any Exam. Any Time.” – www.actualtests.com 55 Checkpoint 156-215-71: Practice Exam
A. Add the Stealth Rule before the last rule.
B. Umit grouping to rules regarding specific access.
C. Place the most frequently used rules at the top of the Policy and the ones that are not frequently used further down.
D. Place a network-traffic rule above the administrator access rule.

Correct Answer: C
QUESTION 139
An Administrator without access to SmartDashboard installed a new IPSO-based R71 Security Gateway over the weekend. He e-mailed you the SIC activation key. You want to confirm communication between the Security Gateway and the Management Server by installing the Policy. What might prevent you from installing the Policy?
A. You first need to create a new UTM-1 Gateway object, establish SIC via the Communication button, and define the Gateway’s topology.
B. You have not established Secure Internal Communications (SIC) between the Security Gateway and Management Server You must initialize SIC on the Security Management Server.
C. An intermediate local Security Gateway does not allow a policy install through it to the remote new Security Gateway appliance Resolve by running the tw unloadlocal command on the local Security Gateway.
D. You first need to run the fw unloadlocal command on the R71 Security Gateway appliance in order to remove the restrictive default policy.
Correct Answer: B
QUESTION 140
Which command would provide the most comprehensive diagnostic information to Check Point Technical Support?
A. diag
B. cpinfo -o date.cpinfo.txt
C. netstat > date.netstat.txt
D. cpstat > date.cpatat.txt

Correct Answer: B

CheckPoint 156-215 exam dumps provide you with test questions that are covered in details and utmost care is taken in selecting the right answers. Top IT industry experts and professionals make sure that the students get thoroughly researched 100% authentic answers.The CheckPoint 156-215 exam dumps are available in pdf and software format. This makes it very convenient for you to follow the course study and exam whenever and wherever you want.

Welcome to download the newest Pass4itsure ns0-155 Practice Test dumps: http://www.pass4itsure.com/ns0-155.html

CheckPoint 156-215 Free Dowload, The Most Effective CheckPoint 156-215 Study Guide Are The Best Materials

Continue Reading

100% Pass CheckPoint 156-215 Exam By Training CheckPoint 156-215 Exam Dumps

Welcome to download the newest Flydumps 156-215 VCE dumps: https://www.pass4itsure.com/156-215.html

Exam A
QUESTION 1
Which VPN-1 NGX feature or command allows Security Administrators to revert to earlier versions of the same Security Policy?
A. Policy Package management
B. cpinfo
C. cpconfig
D. Database Revision Control
E. upgrade_export/import

Correct Answer: D
QUESTION 2
In SmartView Tracker, you see an entry for an outbound connection showing address translation. But when setting SmartView Tracker to show all entries for that connection, only outbound entries show. What is the possible cause for this?
A. The entry is for a Manual Dynamic NAT connection, from a specific host infected by a worm.
B. The entry is for a Manual Static NAT connection, where inbound traffic is managed by a separate rule.
C. The entry is for a Static NAT connection, from a specific host that has been infected by a worm.
D. The entry is for a Dynamic NAT connection from a specific host.

Correct Answer: B
QUESTION 3
Which of the following commands is used to restore VPN-1 NGX configuration information?
A. gunzip
B. cpconfig
C. fw ctl pstat
D. cpinfo
E. upgrade_import

Correct Answer: E
QUESTION 4
Which OPSEC server is used to prevent users from accessing certain Web sites?
A. CVP
B. DEFENDER
C. URI
D. FTP
E. UFP

Correct Answer: E
QUESTION 5
Your organization Certkiller .com’s security infrastructure separates Security Gateways geographically. You must request a central license for one remote Security Gateway. How would you request and apply the license?
A. Request a central license, using the remote Security Gateway’s IP address. Apply he license locally with the fwputlic command.
B. Request a central license, using the SmartCenter Server’s IP address. Apply the license locally on the remote Gateway with the fwputlic command.
C. Request a central license, using your SmartCenter Server’s IP address. Attach the license to the remote Gateway via SmartUpdate.
D. Request a central license, using the remote Gateway’s IP address. Attach the license to the remote Gateway via SmartUpdate.
E. Request local licenses for all Gateways separately. Apply the license locally on the remote Gateways with the fwputlic command.

Correct Answer: C
QUESTION 6
How do you create more granular control over commands, such as CWD and FIND, in FTP data connections?
A. Use Global Properties > Security Server settings.
B. Use the gateway object’s Security Server settings.
C. Use the Service field of the Rule Base.
D. Use an FTP resource object.
E. Use FTP Security Server settings in SmartDefense.

Correct Answer: E
QUESTION 7
Which of the following is the final step in a VPN-1 NGX backup?
A. Test restoration in a non-production environment, using the upgrade_import command.
B. Move the *.tgz file to another location.
C. Copy the conf directory to another location.
D. Run the upgrade_export command.
E. Run the cpstop command.

Correct Answer: B
QUESTION 8
Choose the BEST sequence for configuring user management on SmartDashboard, for use with an LDAP server:
A. Configure a server object for the LDAP Account Unit, enable LDAP in Global Properties, and create an LDAP server using an OPSEC application.
B. Configure a server object for the LDAP Account Unit, enable LDAP in Global Properties, and create an LDAP resource object.
C. Enable LDAP in Global Properties, configure a host-node object for the LDAP Server, and configure a server object for the LDAP Account Unit.
D. Configure a server object for the LDAP Account Unit, and create an LDAP resource object.
E. Configure a workstation object for the LDAP server, configure a server object for the LDAP Account Unit, and enable LDAP in Global Properties.

Correct Answer: C
QUESTION 9
You want to create an IKE VPN between two VPN-1 NGX Security Gateways, to protect two networks. The network behind one Gateway is 10.15.0.0/16, and network 192.168.9.0/24 is behind the peer’s Gateway. Which type of address translation should you use, to ensure the two networks access each other through the VPN tunnel?
A. Hide NAT
B. None
C. Dynamic NAT
D. Static NAT
E. Manual NAT

Correct Answer: B
QUESTION 10
Yoav is a Security Administrator preparing to implement a VPN solution for his multisite organization. To comply with industry regulations, Yoav’s VPN solution must meet the following requirement:
*
Portability: Standard

*
Key management: Automatic, external PKI

*
Session keys: Changed at configured times during a connection’s lifetime

*
Key length: No less that 128-bit

*
Data integrity: Secure against inversion and brute-force attacks What is the most appropriate setting Yoav should choose?

A.
IKE VPNs: AES encryption for IKE Phase 1, and DES encryption for Phase 2; SHA1 hash

B.
IKE VPNs: SHA1 encryption for IKE Phase 1, and MD5 encryption for Phase 2; AES hash

C.
IKE VPNs: CAST encryption for IKE Phase 1, and SHA1 encryption for Phase 2; DES hash

D.
IKE VPNs: DES encryption for IKE Phase 1, and 3DES encryption for Phase 2; MD5 hash

E.
IKE VPNs: AES encryption for IKE Phase 1, and AES encryption for Phase 2; SHA1 hash

Correct Answer: E

Flydumps 156-215 dumps with PDF + Premium VCE + VCE Simulator: https://www.pass4itsure.com/

Continue Reading